polar start ps 2700 install manual

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=38483
Printed Date: May 14, 2024 at 10:49 PM

Topic: polar start ps 2700 install manual

Posted By: matt_willie
Subject: polar start ps 2700 install manual
Date Posted: September 02, 2004 at 12:12 AM

i'm looking for a install manual for ps-2700. i've presently have it hooked up in a 04 astro cargo van.It turns over and starts then shuts off and continues to crank over.after that when i start it with key the service engine light stays on.any help would be great.

Replies:

Posted By: kgerry
Date Posted: September 04, 2004 at 2:49 PM

are you powering all the required ign and acc circuits?.... sounds to me like you are leaving a second ign unpowered

-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer

Owner/Installer
Classic Car Audio
since 1979

Posted By: matt_willie
Date Posted: September 08, 2004 at 6:50 PM

i found a manual and located the correct tach wire. i have set the tach but the van continues to not won't to stay running.do you have to bypass the passlock or not

Posted By: trogguy
Date Posted: September 13, 2004 at 8:45 PM

Where did you locate a manual for the PS-2700? I was given one from a co-worker and need to get it installed. Any help would be appreciated....

Posted By: CanadianJimmy
Date Posted: October 13, 2004 at 7:21 AM

Im also looking for the manual for the ps-2700, has anyone found one online ? or does anyone have one that can tell me what wires go where ? It was installed on a 97 jimmy i purchased and all the wires aren't hooked up so Im not sure if it completely installed correctly or not.

One main thing is can someone tell me the correct connection for the little white plug ? the pins it connect to is larger then it. I take it the tappered side of the plug goes against the part of the board that holds it down but where does it go ? top or bottom

Thanks for any help