deadening for SPL

Home / the12volt's Install Bay / Car Audio / deadening for SPL (

Topic Closed)

Welcome Guest :)

Members

< Prev Page < Prev Topic Next Topic >

Poormanq45

Silver - Posts: 597

Joined: October 27, 2004

Location: United States

Posted: April 08, 2005 at 7:27 PM / IP Logged

dwarren wrote:

If you use that expandable foam be very conservative with it, using too much in between panels will cause them to warp!

Only if you seal the panel before the foam is done completely expanding.

I have had good success using rubber undercoating in a can, $4 at home depot, combined with Great stuff Expanding Foam, $4 home depot.

As for the appearance issue, you can put th etrunk lining back on once the panels are done. Meaning it would look like a stock trunk.

armyranger

Member - Posts: 17

Joined: March 22, 2005

Location: United States

Posted: April 09, 2005 at 6:57 AM / IP Logged

if you are going to use both use the spray first it will fill in all the indintations and give you a better surface for the mat to adhire to .

live like theres no tomarrow because today may be your last.

vwgolf1128

Copper - Posts: 120

Joined: February 11, 2005

Location: United States

Posted: April 09, 2005 at 1:17 PM / IP Logged

vwgolf1128 wrote:

I am also looking at buying deadening. I have a hatchback, and was wondering how many layers a hatch usually needs. I think i read somewhere that 2 is normal. Also how does eDead v1 se compare to Dynamat Extreme?

anyone?

Volkswagen Golf

Alpine CDA-9851

Alpine MRD-M501

Alpine 12" Type R Ported

Alpine Guy is my hero

armyranger

Member - Posts: 17

Joined: March 22, 2005

Location: United States

Posted: April 10, 2005 at 2:35 AM / IP Logged

depending on the deadener used i would recomend at least 2 layers. in a hatch be sure you do the whole car.the roof and floor should be your main concern. as for which is better i prefer dynamat but the difference acousticly is more than likely inaudible

live like theres no tomarrow because today may be your last.

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

deadening for SPL

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.