the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

06 Accord alarm/remote start wiring


Post ReplyPost New Topic
< Prev Topic Next Topic >
solartech 
Member - Posts: 28
Member spacespace
Joined: January 05, 2005
Location: United States
Posted: October 12, 2006 at 12:09 PM / IP Logged  

Hi, I need the wiring codes for putting in a starter/alarm for an 06 Accord, need ASAP

Thanks

Solartech Window Tinting & Electronics Inc.
josh1979 
Silver - Posts: 320
Silver spacespace
Joined: July 03, 2006
Location: United States
Posted: October 12, 2006 at 10:50 PM / IP Logged  
12volts white (50A)  +  ignition harness
Starter BLACK/ white  +  ignition harness
Second Starter N/A    
Ignition BLACK / YELLOW  +  ignition harness
Second Ignition N/A    
Third Ignition N/A    
Accessory BLACK/ red  +  ignition harness
Second Accessory WHITE/ red  +  ignition harness
Keysense RED / white or RED / black  -  ign harn or MICU, green plug, pin 13
Notes: The MICU (Multiplex Integrated Control Unit) is part of the underdash fuse/relay box. The plug(s) for the MICU is on the left side edge of the fuse/relay box.
Power Lock pink/black  -  MICU, green plug, pin 25
Notes: The MICU (Multiplex Integrated Control Unit) is part of the underdash fuse/relay box. The plug(s) for the MICU is on the left side edge of the fuse/relay box.
Meter this wire while pressing the passenger door lock switch.
Power Unlock pink/blue  -  MICU, green plug, pin 9
Notes: The MICU (Multiplex Integrated Control Unit) is part of the underdash fuse/relay box. The plug(s) for the MICU is on the left side edge of the fuse/relay box.
Meter this wire while pressing the passenger door lock switch.
Lock Motor yellow/black  5wi frt of fuse box, lt. grn 12 pin plug
Unlock Motor YELLOW /GREEN  5wi frt of fuse box, lt. grn 12 pin plug
Parking Lights+ RED / black  +  top of fuse box, large white plug
Parking Lights- RED / black  -  headlight switch in column cover
Hazards GREEN/ red  +  top of fuse box, large white plug
Turn Signal(L) RED / blue  +  top of fuse box, large white plug
Turn Signal(R) brown  +  top of fuse box, large white plug
Reverse Light green  +  driver kick, harness to rear
Door Trigger see notes  -  back of fuse box
Notes: The LF door is green in a lt. green 16 pin plug, pin 15. The RF door is lt. GREEN/ red in a lt. green 14 pin plug, pin 12. The LR door is GREEN/ YELLOW in a lt. green 16 pin plug, pin 14. The RR door is GREEN / WHITE in a lt. green 14 pin plug, pin 13. Use all four wires and diode isolate each.
Dome Supervision GREEN/ red  -  back of fuse box, lt. grn 5 pin plug
Trunk/Hatch Pin blue/black  -  MICU, green plug, pin 24
Notes: The MICU (Multiplex Integrated Control Unit) is part of the underdash fuse/relay box. The plug(s) for the MICU is on the left side edge of the fuse/relay box.
Hood Pin yellow/red to GREEN/ black  -  hood pin switch in latch
Trunk/Hatch Release YELLOW /GREEN  +  driver kick, harness to rear
Power Sliding Door N/A    
Factory Alarm Arm blue/white to WHITE/ red  -  driver door module in door
Factory Alarm Disarm BLACK/ red to white  -  driver door module in door
Disarm No Unlock see factory alarm disarm    
Tachometer blue/red or blue  ac  ECM/PCM
Notes: The ECM/PCM is on the front of the transmission tunnel. The connectors are on the passenger side. On the 4 cylinder models the tach wire is in the white 31 pin connector E, pin 25. On the 6 cylinder models it is in the gray connector A, pin 23.
Can also go to any ignition coil and use the wire that is NOT BLACK/ white or black.
Can also go to any fuel injector and use the wire that is NOT yellow/black.
Wait to start N/A    
Brake Wire WHITE/ black  +  brake pedal switch
Parking Brake GREEN/ orange  -  top of fuse box, large white plug
Horn Trigger GREEN/ YELLOW  -  horn switch
Memory Seat 1 N/A    
Memory Seat 2 N/A    
Memory Seat 3 N/A    
06 Accord alarm/remote start wiring -- posted image.
Interface Module:Category:
Immobilizer Bypass
Required:
Yes
Type:
Transponder
Part #: 556HW
Alternate Part1 #: 556UW
Alternate Part2 #: DesignTech 20402
Alternate Part3 #: DesignTech 29402
Notes: Standard on all models. When using the 556HW, follow the mode 1 wiring diagram. The reference wire is BROWN / yellow, data wire is RED / blue and ignition wire is BLACK / YELLOW.
06 Accord alarm/remote start wiring -- posted image.
Smart Starter Kill Relays: Not Available
bring back the rotary phone so i dont have to press 1 to proceed in english

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, October 31, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer