command start programing

Home / the12volt's Install Bay / Car Security and Convenience / command start programing (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

cdnemsguy

Member - Posts: 7

Joined: October 17, 2004

Location: Canada

Posted: November 01, 2008 at 11:47 AM / IP Logged

I cannot get the command start to go into programming mode. I pull the hood switch to ground, lights on for 3 seconds, then bump hte switch , get the lights again, bump the switch again but the lights will not stay on to indicate it is in the program mode. Am I doing something wrong here? Please help.

cdnemsguy

Member - Posts: 7

Joined: October 17, 2004

Location: Canada

Posted: November 01, 2008 at 4:24 PM / IP Logged

I found the antenna had got disconnected so after plugging that it, all works well. The only thing I need to find now is what settings are in the box.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

command start programing

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.