I have had my stereo installed for a while now and i have the whining noise that pass through to my speakers from my 4 channel amp. This is the first time i have encountered the whining noise on any of my installs. The noise only comes when i start the truck, and i can only hear it if my radio is turned down really low, almost to the point of no music passing though, but it does whine with engine acceleration. My first initial fix was trying a ground loop isolator, but i still had the noise. The only thing that made the noise go away was lowering the gain, but by doing that the output voltage of the head unit is not matching up with the amp and my mids and highs volume is not where i want it. I am not trying to use the gain as a volume, but i am trying to match the output signal voltage of the head unit. The volume is also out of sync with my mono amp. I don't have any issues with the mono amp giving off noise at all.
I am using a different route of tuning my installs with a multimeter and testing the output voltage of the amp to the speakers. I wanted to tune it like this because in my opinion it matches your output voltage of the headunit with the amp better than just by ear without any additional enhancements turned on, and everything should sounds more in sync. Now for my mids and highs they run at 80watts rms and when tuning with everything on the head unit set at flat with all enhancements off my output voltage of the amp should be 17.88v per channel using 1khz test tone which puts my gain for my 4 channel amp in between quarter and half and i am getting noise. Used the same route for my mono amp and i am not getting any noise.
Stereo Components:
Headunit: Pioneer DV 4000
Mono Amp: Alpine MP850 Running 4 gauge from battery, and 4 gauge ground wire
4 Channel Amp: MB Quartz ONX 4.80 Running 8 gauge from battery, and 8 gauge ground wire with speakers wires ran individually to each speaker.
RCA: Schoshe Scosche-EFX ReVo for both mono and 4 channel amp ran on opposite side of power wires.
Ground: For the ground i attached it for both amps on that back bar that runs a long the back of the cab in my 2011 tacoma on the double cabs. Usually plastic bins bolt onto it. I sanded down the paint before grounding, and my ground wires are about 1' long. The mono amp gets no noise at all, but i cant figure out why i am getting this noise with the 4 channel amp with gain set under half way. If i disconnect the RCA's from the 4 channel amp i don't get the noise.
Is having the gain not even set half way too high, or is lowering it just masking the problem? From what i understand is that the noise will still be in the system with the gain turned down even if i cant hear it, and raising the gain just amplifies the sounds to where i can hear it. I really want the noise gone and not just using filters to band aide fix it. Any help would be appreciated.