Wiring Info for 04 Jeep Grand Cherokee

DIRECTWIRE™ WIRING INFORMATION - JEEP / GRAND CHEROKEE / 2004 / Remote Start 12volts red & pink/black   +   ignition harness Starter yellow   +   ignition harness Second Starter N/A        Ignition dk. blue   +   ignition harness Second Ignition N/A        Third Ignition N/A        Accessory RED / black   +   ignition harness Second Accessory BLACK/ orange   +   ignition harness Keysense           Power Lock ORANGE / black - ORANGE / purple   5wi door lock switches Notes: Use ORANGE / black and pink/black at the driver door lock switch to lock and unlock the driver door. Use ORANGE / purple and pink/purple at the passenger door lock switch to lock and unlock all of the other doors. Can also use Directed part 455J door lock interface control module. This will control door lock, unlock, arm disarm, dome light supervision and more. Power Unlock pink/black - pink/purple   5wi door lock switches Notes: Use ORANGE / black and pink/black at the driver door lock switch to lock and unlock the driver door. Use ORANGE / purple and pink/purple at the passenger door lock switch to lock and unlock all of the other doors. Can also use Directed part 455J door lock interface control module. This will control door lock, unlock, arm disarm, dome light supervision and more. Lock Motor ORANGE / black   5wi driver door lock switch Unlock Motor pink/black   5wi driver door lock switch Parking Lights+ do not use        Parking Lights- yellow   -   headlight switch Notes: Parking lights require a negative trigger thru a 1300 ohm resistor. There is a rest resistance on the wire, so MUST use a relay to isolate away from the switch. Hazards dk. blue/pink   -   steering column Notes: The hazards will flash even with a latch input to the wire. Turn Signal(L)           Turn Signal(R)           Reverse Light           Door Trigger see notes   -      Notes: The driver door trigger is tan/red at the driver door lock switch. The passenger door is tan/red at the passenger door lock switch. The driver rear door is tan/orange and the passenger rear door is tan / YELLOW at the BCM. Use all four wires and diode isolate each. WHEN USING A 455J INTERFACE MODULE, IT IS NOT NECESSARY TO USE THE SEPARATE TRIGGER WIRES. USE THE YELLOW WIRE AT THE UNDERDASH LIGHT FOR DOOR TRIGGER. Dome Supervision yellow/dk. green   -   BCM, above diagnostic plug Notes: Can also use Directed part 455J door lock interface control module. This will control door lock, unlock, arm disarm, dome light supervision and more. Trunk/Hatch Pin tan/black   -   BCM, above diagnostic plug Hood Pin           Trunk/Hatch Release           Power Sliding Door N/A        Factory Alarm Arm arms with lock        Notes: Can also use Directed part 455J door lock interface control module. This will control door lock, unlock, arm disarm, dome light supervision and more. Factory Alarm Disarm lt. GREEN/ orange   -   driver door lock switch Notes: Can also use Directed part 455J door lock interface control module. This will control door lock, unlock, arm disarm, dome light supervision and more. Disarm No Unlock           Tachometer see notes   ac      Notes: The 4.7L motor has a separate coil for each cylinder. Go to any coil and use the wire that is NOT dk. GREEN/ orange. On the 4.0L use any of the tan/stripe wires at the coil pack, or go to one of the fuel injector and use the wire that is NOT dk. GREEN/ lt. green. Wait to start N/A        Brake Wire WHITE/ tan or PURPLE / brown   +   driver kick panel Parking Brake           Horn Trigger gray/orange   -   steering column Memory Seat 1           Memory Seat 2           Memory Seat 3           Immobilizer Bypass Module: Required: Yes Type: Sentry Key Part #: 555C, 556U, or 555U Notes: Only vehicles with gray keys have the immobilizer.

http://www.directechs.com/guides/manuals/ig/accessories/N556U_09-04.pdf The link provided above is for the DEI 556U bypass module. Regards EVIL Teken . . .

I don't believe it is possible to reuse a 555C on a second vehicle. You will probably need to buy a new one.

JWorm wrote: I don't believe it is possible to reuse a 555C on a second vehicle. You will probably need to buy a new one.

That is correct. Once a module from Jeep or Chrysler has been programmed, you can not use this in another vehicle with the Sentry System.

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA