fuel pump cutoff

ok, here is a drawing, three relays, one push buton, and one NORMALLY CLOSED reed magnet setup, you will have to get the wire for the fuse of the fuel pump, or sometihng like that, the power for the pump, or heck, even just an ignition wire or something like that to do this, your choice, hope you can understand this, the first two relays basically just set up a latching sytem, so you don't have to have a buton held down (if you know what i mean by that) the last relay actually cuts off or connects power to the fuel pump, and the reed switch will basically be the stopper for the latched relays, it will turn them off, i drew it in standard electronics relays, so that's why i put the legeond down there, most people don't draw relays like that anymore, but i labled the pins, so if you just run the wires like i labled the pins on the legend you should be good, if you need any other help just msg me

ohh and i outlined each switch and each relay to kinda make it a little less confusing, i know it's a mess, i had to hand draw it, i didn't think i could make it look any good on paint,, haha,, try and figure out my mess..

I could do it with much less componants then that, just 1 relay and i can do you a professinal drawing if you want me to.