dei 530t mitsubishi lancer 2002

One question. If you remove your ignition key does that driver's door switch panel stay live for about 1 minute?

No it does not retain any voltage once key is removed.

The drivers side switch panel only works in accessory or in run position with ignition. Once turned off and key removed.. no power retained. The one touch only applies to the driver window to put it down all the way. 

That's what I wanted to know. Place the 530t in centre of car and run leads to front doors to motor wires. If using 2, one in and around driver's kickpanel for left hand pair and passenger kick panel for right hand pair. You will retain full factory control, closing and venting from your remote and all the switches will now be one touch.

Excellent..thank you for clarifying that for me. I will be placing the 530t in my center console near gear shiftter as my viper 350hv control module is right there for connections.. the Aux channel (RED / white) , ground when armed output, and (-) blue trigger wire from alarm  which I will connect the gray (-) output during activation wire from the 530t with the relay between the brain and the trigger sensors to bypass them during -output as you said before.  I have 14 gauge wire ready to use for the extension into the doors. I'll let you know how everything turns out.  thanks again!

Would it be best to connect both ground path motor wires  and the main ground of the 530t all at the same location... and make them a short distance to ground connection rather than extended? thanks

The shorter the better for all leads.