viper 5901 remote start problem

I tested just disconnecting H2/16, but the result was same. should I wire through a push switch? removing is not enough?

No, that's OK, leave as is. Where are you in France?

im in baltic state right now. its northern/eastern europe. and installing in friends garage. long story. i was kinda hoping that i could finish installing already...

Shame, hoping France, I'm only 25 minutes from the tunnel on Friday. A quick job, finished by 09:30 then a free day. Would have been nicer then driving back to North London! OK do the following. I assume your by-pass is triggered by the GWR (status wire at H2/9). Ground that wire then hot wire from your constant feeds, first to the 2 x ignition wires then the two starter wires. Let's see if that starts the vehicle (allow 5 seconds between ignition and start for the glow plugs). If so try and emulate that with your R/S. Also program virtual tach. I just remembered recent problems with a mid 90s Land Cruiser Amazon. Solved by going to V/Tach.

thanks really. i definitely would come if i was in france now. im dying. i remember that engine started by grounding H2/9, connecting 2x ignition wires and starter wires to constant feeds. ill go through program settings tomorrow. at mode, virtual tach, diesel timer.

i went through settings. still not working...

is there any possibility of initial failure?

In my experience virtually NIL on a 5704. Set it up and test the outputs on your H3 wires. Pink Pink/white Orange Violet, also continuity between green and violet with the alarm turned off.

you mean there was no error? im guessing there is something wrong with H3/1 or H3/6 relay in the brain box. it stops remote start process (shuts off all the output. wont even attempt cranking (no output from starter wire)) as soon as i connect H3/1.

okay, i'm back in work. I replaced brain with brand-new tested one. and I resetting brain programming with bitwriter. and result stays same. means brain was fine. now I have to find and try another possibilities... The point is I can start engine manually as howie ll says (Posted: July 04, 2013 at 7:18 PM). this means I connected wires correctly. So I guess, now I have to fix connections not to shut brain off while processing remote start. (http://www.youtube.com/watch?v=S6h2DmaUvBA&feature=youtu.be) but I don't know what could shut off the remote start process like the movie I uploaded on youtube. things I know so far: 1. connected wires correctly as manual says. 2. brain shuts off as soon as current flows in ignition1 through brain. (as soon as I connect H3/1 or H3/6 (IG1 input/ouput). remote start works without H3/1 or H3/6. but starter motor won't stop in this case.) if anyone have any ideas, please help me!!