the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

diagram for 98 grand prix gtp

Home / the12volt's Install Bay / Car Security and Convenience / diagram for 98 grand prix gtp (Topic Closed Topic Closed)
Welcome Guest :)

Post ReplyPost New Topic
< Prev Topic Next Topic >
fst100 
Copper - Posts: 60
Copper spacespace
Joined: September 06, 2005
Location: United States
Posted: December 31, 2005 at 3:02 PM / IP Logged  

im looking for the wiring diagram and the passlock immobolizer part number for:

98 Pontiac Grand Prix GTP Auto

Currently i have the Viper 160XV Remote Start/Security, but I plan on just installing the remote start because the vehicle has a stock keyless entry/security.  Again I'm looking for the wiring diagram for the GTP, where and what color the tach wire is, the ignition harness(es), and so forth aswill as the best possible places to solder/tap the viper onto the vehicle harness.  the other request is the bypass module for the passlock and the wiring schematics for it.  I do thank you guys for all of your help, i had alot of help from the past from the people on this site, my applause to you all.

p.s.-i have an AIr/Fuel Gauge i want to install, where is the O2 sensor signal wire located in the engine bay?

fst100 
Copper - Posts: 60
Copper spacespace
Joined: September 06, 2005
Location: United States
Posted: January 01, 2006 at 10:22 AM / IP Logged  
after much searching i realize that starting after 99+ that the grix's has the passlock III, i currently have a 98, would that mean that it has the passlock II on it?  if so what DEI bypass module would i need to get pass it?  i know for my 99 cavalier i needed a 555L, what part number from DEI would i need for the 98 grand prix?  also i found the wire laout in the other forums, but my question was if i could just skip the viper security and just install the remote starter on the vehicle.  thanks.
Mharvey 
Copper - Posts: 76
Copper spacespace
Joined: October 27, 2004
Location: United States
Posted: January 01, 2006 at 10:43 AM / IP Logged  
Battery BROWN AND ORANGE (+) PSC/ECU MODULE TO THE RIGHT OF GLOVE BOX PINS 12/33 OF 40 PIN PLUG diagram for 98 grand prix gtp -- posted image.
diagram for 98 grand prix gtp -- posted image.Ignition 1 YELLOW (+) PSC/ECU MODULE TO THE RIGHT OF GLOVE BOX PIN 35 OF 40 PIN PLUG diagram for 98 grand prix gtp -- posted image.
diagram for 98 grand prix gtp -- posted image.Starter 1 BLUE (+) PSC/ECU MODULE TO THE RIGHT OF GLOVE BOX PIN 15 OF 40 PIN PLUG diagram for 98 grand prix gtp -- posted image.
diagram for 98 grand prix gtp -- posted image.All Door Trigger BLACK/ WHITE (-) AT PLUG TOP OF FUSEBOX 
diagram for 98 grand prix gtp -- posted image.Domelight Super BLUE 
diagram for 98 grand prix gtp -- posted image.LF Latch RED (-) BECU PIN 14 OF A 16 PIN PLUG diagram for 98 grand prix gtp -- posted image.
diagram for 98 grand prix gtp -- posted image.RF Latch RED (-) BECU PIN 23 OF A 28 PIN PLUG diagram for 98 grand prix gtp -- posted image.
diagram for 98 grand prix gtp -- posted image.LR Latch GREEN (-) BECU PIN 11 OF A 28 PIN PLUG diagram for 98 grand prix gtp -- posted image.
diagram for 98 grand prix gtp -- posted image.RR Latch BLUE (-) BECU PIN 16 OF A 16 PIN PLUG diagram for 98 grand prix gtp -- posted image.
diagram for 98 grand prix gtp -- posted image.Trunk Trigger RED (-) BECU PIN 11 OF A 16 PIN PLUG 
diagram for 98 grand prix gtp -- posted image.Hood Trigger WHITE/ BLUE (-) HOOD PIN SWITCH UNDER HOOD 
diagram for 98 grand prix gtp -- posted image.Alarm Disarm ARMS WITH LOCKS 
diagram for 98 grand prix gtp -- posted image.Alarm Arm DISARMS WITH UNLOCK diagram for 98 grand prix gtp -- posted image.
diagram for 98 grand prix gtp -- posted image.Parking Lights GREEN (+) AT THE BACK OF PARKING LIGHT UNDER HOOD 
 Headlights-Lo BLUE/RED (-) IGNITION SWITCH HARNESS 
diagram for 98 grand prix gtp -- posted image.Wipers-Lo BLUE / YELLOW (-) IGNITION SWITCH HARNESS 
diagram for 98 grand prix gtp -- posted image.Trnk Release LIGHT GREEN (-) BECU PIN 13
Battery BROWN AND ORANGE (+) PSC/ECU MODULE TO THE RIGHT OF GLOVE BOX PINS 12/33 OF 40 PIN PLUG diagram for 98 grand prix gtp -- posted image.
diagram for 98 grand prix gtp -- posted image.Ignition 1 YELLOW (+) PSC/ECU MODULE TO THE RIGHT OF GLOVE BOX PIN 35 OF 40 PIN PLUG diagram for 98 grand prix gtp -- posted image.
diagram for 98 grand prix gtp -- posted image.Ignition 2 LIGHT BLUE (+) PSC/ECU MODULE TO THE RIGHT OF GLOVE BOX PIN34 OF 40 PIN PLUG diagram for 98 grand prix gtp -- posted image.
diagram for 98 grand prix gtp -- posted image.Accessory 1 GREEN (+) PSC/ECU MODULE TO THE RIGHT OF GLOVE BOX PIN 11 OF 40PIN PLUG diagram for 98 grand prix gtp -- posted image.
diagram for 98 grand prix gtp -- posted image.Starter 1 BLUE (+) PSC/ECU MODULE TO THE RIGHT OF GLOVE BOX PIN 15 OF 40 PIN PLUG diagram for 98 grand prix gtp -- posted image.
diagram for 98 grand prix gtp -- posted image.Starter 2 LIGHT BLUE (+) PSC/ECU MODULE TO THE RIGHT OF GLOVE BOX PIN 17 OF 40 PIN PLUG diagram for 98 grand prix gtp -- posted image.
diagram for 98 grand prix gtp -- posted image.Anti-Theft Type UNIVERSAL TRANSPONDER 
diagram for 98 grand prix gtp -- posted image.Anti-Theft Descript THE KEY SENDS A RF SIGNAL TO THE BCM THROUGH A ANTENNA AROUND THE KEY CYLINDER 
diagram for 98 grand prix gtp -- posted image.Key Sense BLUE/WHITE (-) IGNITION SWITCH HARNESS 
diagram for 98 grand prix gtp -- posted image.Neutral Safety GREEN / WHITE (-) AT GEAR SELECTOR SWITCH 
diagram for 98 grand prix gtp -- posted image.Tachometer WHITE (AC) PIN 9 AT THE DATA CONNECTOR 
diagram for 98 grand prix gtp -- posted image.Speed Sense PURPLE (AC) ECU MODULE TO THE RIGHT OF GLOVE BOX PIN 14 OF A 26 PIN PLUG diagram for 98 grand prix gtp -- posted image.
diagram for 98 grand prix gtp -- posted image.Parking Lights GREEN (+) AT THE BACK OF PARKING LIGHT UNDER HOOD 
diagram for 98 grand prix gtp -- posted image.Brake Lights RED / BLACK (+) BRAKE PEDAL 
diagram for 98 grand prix gtp -- posted image.Reverse Lights RED (+) ECU PIN13 diagram for 98 grand prix gtp -- posted image.
diagram for 98 grand prix gtp -- posted image.Horn YELLOW (-) STEERING COLUMN HARNESS
 Power Unlock LIGHT GREEN (-) POWER MASTER SWITCH IN DRIVERS DOOR 
diagram for 98 grand prix gtp -- posted image.PowerLock PINK (-) POWER MASTER SWITCH IN DRIVERS DOOR diagram for 98 grand prix gtp -- posted image.
diagram for 98 grand prix gtp -- posted image.Driver Mtr Unlock RED (REV) ECU IN DRIVERS DOOR 
diagram for 98 grand prix gtp -- posted image.Driver Mtr Lock GREEN (REV) ECU IN DRIVERS DOOR 
diagram for 98 grand prix gtp -- posted image.Pas Mtr Unlock RED (REV) ECU IN PASSENGER DOOR 
diagram for 98 grand prix gtp -- posted image.LF Window Up RED / YELLOW (REV) DRIVERS DOOR SWITCH 
diagram for 98 grand prix gtp -- posted image.LF Window Dn RED / BLUE (REV) DRIVERS DOOR SWITCH 
diagram for 98 grand prix gtp -- posted image.RF Window Up BLUE / YELLOW (REV) DRIVER KICK PANEL 
diagram for 98 grand prix gtp -- posted image.RF Window Dn BLUE (REV) DRIVER KICK PANEL
Mharvey 
Copper - Posts: 76
Copper spacespace
Joined: October 27, 2004
Location: United States
Posted: January 01, 2006 at 10:49 AM / IP Logged  
im not for sure but i looked up the passlock immobolizer  on bypasskit.com and they dont list 1 so i  dont think you need 1
fst100 
Copper - Posts: 60
Copper spacespace
Joined: September 06, 2005
Location: United States
Posted: January 01, 2006 at 10:52 AM / IP Logged  
bypasskit.com is a reliable source i see?  thanks Mharvey
fst100 
Copper - Posts: 60
Copper spacespace
Joined: September 06, 2005
Location: United States
Posted: January 02, 2006 at 7:35 AM / IP Logged  

could i still be able to just install the remote start area and not install the security aspect?

theglassman 
Member - Posts: 2
Member spacespace
Joined: December 07, 2005
Location: Canada
Posted: January 02, 2006 at 6:01 PM / IP Logged  
 i am doing a 98 grand prix tomorrow ,the 98 doesn't need a by-pass kit but there could an oem alarm .if it does you have to program the oem alarm to work with the remote.
fst100 
Copper - Posts: 60
Copper spacespace
Joined: September 06, 2005
Location: United States
Posted: January 02, 2006 at 6:44 PM / IP Logged  
hmm ic, could u let me know theglassman if u'd have to program the oem alarm to work with the remote?  thanks in advance
fst100 
Copper - Posts: 60
Copper spacespace
Joined: September 06, 2005
Location: United States
Posted: January 05, 2006 at 5:57 AM / IP Logged  
*bump^
fst100 
Copper - Posts: 60
Copper spacespace
Joined: September 06, 2005
Location: United States
Posted: February 08, 2006 at 7:59 AM / IP Logged  
glassman, i sent a PM to you, thanks

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, October 31, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer