1995 Nissan 240s
Welcome Guest :)
sclinton
Member -
Posts: 4
Joined: May 25, 2002
Location: United States
Posted: May 25, 2002 at 12:55 PM / IP Logged
I am going to install an alarm on a 240sx and requesting the diagram
Steven C.
Velocity Motors
Moderator -
Posts: 12,488
Joined: March 08, 2002
Location: Manitoba, Canada
Posted: May 26, 2002 at 1:44 AM / IP Logged
Remote Starter Wiring Colors and Notes |
Function | | | Vehicle Color | Location |
Start: | | | BLACK / YELLOW | IGNITION SWITCH HARNESS |
Ignition #1: | | | BLACK/ RED | IGNITION SWITCH HARNESS |
Ignition #2: | | | WHITE | IGNITION SWITCH HARNESS |
Ignition #3: | | | N/A | |
Accessory: | | | WHITE/ BLUE | IGNITION SWITCH HARNESS |
Brake Light: | | | RED / GREEN (+) | SWITCH ABOVE BRAKE PEDAL |
Tach Signal: | | | YELLOW/RED | PIN 3 AT ECCS * |
Parking Lights: | | | RED / BLUE | (+) AT HEADLIGHT SWITCH |
Headlights: | | | SEE NOTES BELOW | ** |
OEM Alarm Disarm: | | | GREEN/ YELLOW (-) | SAME CONNECTOR AS DOORLOCKS |
OEM Alarm Arm: | | | N/A | |
Diesel Glow Plug: | | | | |
Clutch Bypass Wire: | | | | |
Notes: | | * Electronic Concentrated Control System (ECCS) Module Located In Pasenger Kick Panel. Pin #2 Is Also YELLOW/RED Tach Wire. These Wires Are On Short Side Of Connector Near Center Bolt. LT. GREEN/ BLUE At Distributor Is High Signal. ** This Vehicle Is Equipped With Two Start Wires. Both Must Be Powered In Order For Vehicle To Start When Engine Is Cold; |
Alarm and Keyless Entry Wiring Colors and Notes |
Function | | | Vehicle Color | Location |
Constant +12 Volts: | | | WHITE | IGNITION SWITCH HARN.(WHT/RED FOUND) |
Starter Kill: | | | BLACK / YELLOW | IGNITION SWITCH HARNESS |
Ignition +12 Volts: | | | BLACK/ RED | IGNITION SWITCH HARNESS |
Dome Lights/Superv: | | | RED / WHITE | (-) DRIVER KICK PANEL *** |
OEM Horn: | | | GREEN / WHITE (-) | STEERING COLUMN HARNESS OR AT RELAY |
Power Lock: | | | LIGHT GREEN / WHITE | @ WHITE 12 PIN CONN. IN DR. KICK **** |
Power Unlock: | | | BROWN / RED | @ WHITE 12 PIN CONN. IN DR. KICK **** |
Trunk Release: | | | N/A | |
Alarm Input Wire: | | | RED / WHITE | (-) DRIVER KICK PANEL *** |
Notes: | | *** SE Models Are Diode Isolated. Wire In Bottom Row Of Main Body Harness Conn. In Driver Kick Panel. Proper Wire On Base Model Is BLUE. **** Negative Pulse Door Lock . |
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
sclinton
Member -
Posts: 4
Joined: May 25, 2002
Location: United States
Posted: May 28, 2002 at 8:15 AM / IP Logged
Thanks a Lot This is going to be my first install on a 240sx !!!!
Steven C.
Velocity Motors
Moderator -
Posts: 12,488
Joined: March 08, 2002
Location: Manitoba, Canada
Posted: May 28, 2002 at 9:51 AM / IP Logged
Good luck If you need any more help just post your requests.
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Follow the12volt.com
Wednesday, September 25, 2024
• Copyright © 1999-2024 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.