Viper 5706V With Omegalink Bypass Module, 2007 Nissan Titan

This is not handled by D2D as hood is not annotated by the red dashed lines and I don't see one on any factory diagrams. You will need to run this yourself if you want it as an input for your system. The hood pin switch does two things: 1) It triggers the alarm if the hood is popped while armed. 2) Shutdown the remote start

I missed the hood pin when I asked about the RS Auxiliary/shutdown/trigger harness 24-pin connector question. Then I will need the 24-pin harness connector for this one wire after all. What about brake shutdown input, neutral safety/parking brake input and horn honk output on the 24-pin harness will I need to hard wire these or is this already connected through the D2D? I don't see horn honk output on D2D and not sure if brake status is the same as brake shutdown and E-parking brake is the same as neutral safety/parking brake.desertislandertech

If you want horn honk you will need to hardwire it also. Brake (status/shutdown) and e-brake should both be handled D2D. If for whatever reason this doesn't work you can hardwire those also. Sometimes I'll leave some extra wire just in case I need to make changes later.

Got it thanks. I'll leave the rest of the unused wires intact in case I need it down the road.desertislandertech