python 5401p on 97 f250

My last post was WRONG. Discard the green, connect the purple to the blue/black in the driver kick panel.

So then I will need to put in a relay because I have positive trigger? I listed it all and it should be right

No the violet goes to that positive trigger.

And that will have nothing to do with it failing to R/S unless you've tied one of those two as a hood pin.

Ok thanks. The hood pin wire is not used I will make a complete list

Main harness H1/1 red-12v H1/2 black-ground H1/3 brown-siren H1/4 WHITE/ brown parking light Iso-not connected H1/5 white-brown at headlight switch H1/6 orange ground when armed- not connected Door lock Blue- unlock relay Green- lock relay Auxiliary harness H2/1 pink/white (-)200ma ignition/flex relay- not connected H2/2 BLACK/ white (-)nss- ground H2/3 blue/white (-)200ma 2nd status/rear defogger output- not connected H2/4 GREEN/ black (-)200ma oem alarm disarm output- not connected H2/5 RED / white (-)200ma trunk release output- not connected H2/6 green door trigger(n/c or n/o)- not connected H2/7 BLACK / YELLOW (-)200ma dome light supervision-relay H2/8 BROWN / black (-)200ma horn output-dark blue H2/9 dark blue status output- not connected H2/10 pink (-)200ma ignition1 output- not connected H2/11 WHITE/ black (-) 200ma aux3 output- not connected H2/12 violet (+) door trigger- BLACK/ blue H2/13 WHITE/ violet (-) aux1 output- not connected H2/14 violet/black (-) aux2 output- not connected H2/15 ORANGE / black (-) aux4 output- not connected H2/16 brown (+) brake shutdown- light green H2/17 grey (-) hood pin n/o or n/c- not connected H2/18 violet / YELLOW (-) 200ma starter output - not connected H2/19 blue trunk pin instant trigger n/c or n/o - not connected H2/20 gray/black diesel wait to start- not connected H2/21 whit/blue (-) remote start/turbo timer activation- not connected H2/22 orange (-) accessory output- not connected H2/23 violet/white tachometer input-WHITE/ pink at tach H2/24 GREEN / WHITE (-)200ma oem alarm arm output- not connected Remote start H3/1 pink ignition 1 input/output - RED / light green H3/2 RED / white 12v H3/3 orange accessory output-gray / YELLOW H3/4 violet starter output- car side of RED / lt blue H3/5 green starter input- key side of RED / lt blue H3/6 red-12v H3/7 pink/white ignition2- BLACK/ lt green H3/8 pink/black flex relay input 87a key side- not connected H3/9RED / black- 12v

My confusion was due to a discrepancy between the wiring that came with the alarm and the one I pulled offline yesterday. I was at work and didn't have my cut sheet with me. The online version shows a negative door trigger input and the python supplied one shows a positive door trigger input. I knew I had checked this out several times.

Use the single wire blue/black (+) POS. Much easier that finding all of them, dioding them etc.

Yeah that's what I did. The alarm worked fine just no remote start. Thanks

So do all of my connections seem to be in order