viper 5902 + dball in hyundai 2012

What you mean YES for those. Loom all the below ?????????? H1/4 WHITE/ Brown Parking light isolation wire - pin 87a of on board relay H1/10 WHITE/ Blue (-) Remort start / Turbotimer activation input (not needed right) H2/7 Grey/Black (-) Diesel wait to start input (as my car is not diesel) H2/11 Pink/White (-) 200 mA flex relay control output H3/5 Green (+) Starter input (key side of starter kill) H3/8 Pink/Black (+) flex relay input 87a key side (if required) of flex relay

Yes. If they aren't on that DB-ALL diagram, then don't use them.

OK thanks Howard

Can you tell what you think about the viper settings i marked in the following pictures The features framed in green are the ones i want to change The features highlighted in red I don't know what to set them The features i framed in blue is another phase will work in next week The features to be programmed with bitwriter

Menu 1/1 Don't even think about doing this the day you leave your keys in the car at 2:00 am in the desert are when you will want to kill yourself. And please don't give me that rubbish about "I never leave my keys in the car". Menu 1/5 Make that lock and unlock,otherwise it will drive you mad, more so your passengers unless you're a taxi driver. Menu 1/ 11, 13 and 14 leave in default. The rest are correct. Menu 2 All OK except 5 leave in default. Menu 3/1 If its an auto then select automatic. Menu 3/2 Tachometer Menu 3/3 Cranking. Leave in default if it turns over but doesn't start, then extend. Menu 3/8 Ignore Menu 3/10 OFF. Menu 3/11 Ignore Menu 4/12 The longer the better. Menu 4/13 4 Menu 4/14 Leave in default. Menu 4 /17 12V Menu 4/20 and 21 up to you. Menu 4/23 Leave in default. You do realise that you're messing around with this one install more than the average installer will do in a year! And boy is this going to give you problems. If it works and it ain't broke, DON'T TOUCH.

Thanks Howard wish me good luck

Good luck. Now no more questions till you've started the install.

If everything works fine next week i will work on the sirens and sensors and accessories

The DBALL doesn't work it flashes orange after programming then red then after a while it is red constant

Does the VIN of my car if it is for middle east affect this or there is no problem about that